Products

Found on units built before 1997 that use roller style bed rails. This pin in installed in the top deck rail, and acts as a stop for the wheels and...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

Measures 3 inches wide by 3 inches tall. Part number 4799C8642

Located just past the whiffle tree. This separator bracket is used to mount the 4 lift system pully's and guide the cables out from the whiffle tre...

The ratchet pawl is part of the mechanical brake for most lift systems. This cam engaging the ratchet wheel sprocket is what gives the Coleman and ...

Used primarily as the cushion stop button on most models until the 1990's. Other applications include tower spacers on shelf and cabinet systems. T...

Plastic refer vent is found on many pop ups campers. Some larger units use two vents, one stacked above the other.  Directly matched to the followi...

Used in pre-1997 bed rails. Spaces the roller wheels out further if required. Some units require up to 3 roller spaces between the bed frame and th...

These brackets fit the the left hand and right hand ends of the 4800-4811 roof brace. They secure to the roof curtain and canvas tracks and hold th...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...

Roof support poles for your pop up camper are now available. Multiple uses: This product can be provide for the added piece of mind of a roof suppo...

Round drive design. The output shaft on this motor has a pin through it. Only two lift motors were used and they are easily identified by the shape...

This lens is solid red. No bottom tag illumination. Dimensions are 8 1/2 inches wide by 4 1/2 inches tall. The complete assembly is found here Part...

This lens is solid red. No bottom tag illumination. The top center is clear for reverse lights. Dimensions are 8 1/2 inches wide by 4 1/2 inches ta...

Fits 17 inch jacks and 20 inch jacks. Sand shoes help stabilize the camper. A wider footprint on the ground equals more comfort with less rocking i...

This collar installs in the front crank housing plate. The pressure washer fits into this assembly. Measures 1-3/4 inches wide on the widest side a...

This latch is found on units where the access door lock sits to the side of the door, mounted in a body panel. Always found on access doors that sw...

White nylon strap with hook and loop Velcro to secure the shower cabinet top when lifted up. Comes with installation hardware. Measures 30 inches i...

This hose connects to the interior or exterior shower valve, then to the shower wand. 60 and 72 inch lengths available. Please select your size fro...

Found on many Coleman and Fleetwood pop ups with galley lift system sinks. Installs to the bottom of the sink and connects to the drain hose. Measu...

Hardware kit for the installation of slide style bed support legs. This kit installs the bed support pole slide channels to the bottom of the bed f...

Square drive design. Only two lift motors were used and they are easily identified by the shape of the drive coupling. This motor incorporates a "s...

The whiffle tree is the threaded rod mounted in the bottom of the pop up. A draw bar runs up and down the rod and pulls or releases the cables. Thi...