Products

Swivel nut with 1/2'' pipe inlet, and 1/2" Male threaded outlet. 50 Mesh Stainless Steel Screen. Clean, clear economical strainers eliminate unnece...

Use your existing water pump to winterize your pop up with ease. Simply install the brass valve to the water pump draw port. To winterize, attach ...

Measures 3 inches wide by 2 inches tall. Part number 4800A1154

These install in the fresh water tank under the camper, and are removed to drain the water from the tank. Two sizes are available.  3/8 Inch 1/2 I...

Fill your water tanks in a fraction of the usual time and eliminate "bubble-back". The large 5/8" fill tube allows you to fill your pop ups water ...

Male pipe threads accept into the water tank, and barbed fittings accept into the water lines. Clamps are available Please select your size from t...

Metal underbelly bracket to mount the fresh water tank. Series 3600 and 3600C Measures 32-1/2 inches wide by 6 inches deep by 6-3/8 inches wide. Pa...

This seal is commonly used for slide out boxes. Two seals stacked together on each side of the slide out box act as a weather barrier. Another loca...

Designed to stop leaks and moisture between doors and hatches. Commonly found behind body panels, and door jams on Coleman and Fleetwood pop ups. S...

Designed to stop leaks and moisture between doors and hatches. Commonly found behind body panels, and door jams on Coleman and Fleetwood pop ups. S...

Designed to stop leaks and moisture between doors and hatches. Commonly found behind body panels, and door jams on Coleman and Fleetwood pop ups. S...

Designed to stop leaks and moisture between doors and hatches. Commonly found behind body panels, and door jams on Coleman and Fleetwood pop ups. S...

Lift Assembly for a Reese 66069 weight distribution system. Rated to 400lb of tongue weight / 4000 GVW Measures 30 inches in length, 5-5/8 inches i...

Trunnion Bar for a Reese 66069 weight distribution system. Comes with shackle block and chain. Rated to 400lb of tongue weight / 4000 GVW Measures ...

4 pack of weld pins and screws. Part number 4716-4591

 Vintage Wesbar taillight with tag illumination. Directly matched to the Coleman Versa Trailers. Measures 4-7/8 inches wide by 4-7/8 inches tall by...

These wheeled carriers are typically found on units produced from 1967 to the 1980's. The track guides are attached to the top of the screen door b...

Ribbed surface for a better grip. Chocks keep your trailer in place so you can camp in confidence. Solidly constructed of durable hard plastic with...

Ribbed surface for a better grip. Chocks keep your trailer in place so you can camp in confidence. Solidly constructed of durable hard plastic with...

Helps stop unwanted movement of your pop up by stabilizing the trailer tongue wheel. This device also keeps the wheel from sinking in soft ground....

Measures 1-1/2 inches inside diameter, 1.987 inch outside diameter. 1/4 of an inch in height. Fits 7-1/4” hubs.  Part number 4714B2201

The coupler connects the whiffle tree or extension rod to the crank assembly. Found on 6311 direct drive systems, and units that use extension rods...

The whiffle tree extension rod was used in early direct drive lift systems. 4 total pin holes to couple to the crank and the whiffle tree, 3 holes ...

Whiffle tree pan found on many Destiny series pop ups. This cover becomes the complete whiffle tree guide, and is bolted to the cross members. Meas...