Crank Assemblies

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...

This popular crank system for Coleman and Fleetwood pop ups is for units with lower direct drive lifts. This crank is found in the rear bumper, dir...

Front mounting plate for both the 3000 and 6311 direct drive crank assemblies.  Measures 7-3/4 inches wide at the base by 3 inches in height.  1-1/...

The lift lock pulls over the whiffle tree and locks the roof in place. Found most commonly on smaller box sized units, that have no crank system. C...

One of the earliest designs of Coleman Crank Handles. This type of crank handle was used from the start of prouction to the 1980's for most units. ...

Used in upper crank assemblies, and the lower left hand chain drive system found on certain 12 foot box units. The crank assembly gears and mechani...

Used in upper crank assemblies. The crank assembly gears and mechanism ride on this drive shaft. The drive hub extension tube threads onto the seco...

Used on lower drive drive crank systems, that are located directly at the center of the bumper. This drive shaft works in the 6311 and 3000 direct ...

This 5/8 nut threads onto the end of coarse thread drive shafts. This is the final nut found on the end of drive shafts for crank assemblies. Early...

Installs on the whiffle tree and holds the 3000 series thrust bearing. Most commonly used on units with chain driven lift systems. Dimensions are 2...

Whiffle tree pan found on many Destiny series pop ups. This cover becomes the complete whiffle tree guide, and is bolted to the cross members. Meas...

This cover bolts to the bottom of the whiffle tree system and adds stability to the lift system. Measures 32-1/4 inches long by 11-1/4 inches wide....

Crank cover for left hand chain drive lift systems. Found on 12 foot box models built between 2000 and 2002. Series 3500 Measures 13-1/4 inches wid...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

The ratchet paw is part of the mechanical brake for most lift systems. This cam engaging the ratchet wheel sprocket is what gives the Coleman and F...

Used on every Coleman and Fleetwood crank assembly that uses a drive hub extension tube. This collar installs in the front crank housing plate. The...

The crank shaft bushing is found a the rear of ratchet and clutch crank assemblies. it supports the rear of the drive shaft. Inserts into a 1 inch ...

Used to reinforce or space the thrust bearing. Measures 4 inches wide and 2-3/4 inches tall. 1-1/2 inch diameter hole. Color : White Part number 47...

Used on coleman and Fleetwood pop up with an upper or left hand crank assemblies. The chain runs from the crank assembly to this gear. This gear th...

Found on 3 stage highwall lift arms, this is the bottom section. Highwall units typically have body panels that measure 28 inches in height. The to...