Power Lift

Looking for an easy solution to make your camper a "power lift" model? This crank adapter does just that! Works with both plug in or cordless drill...

Looking for an easy solution to make your camper a "power lift" model? This crank adapter does just that! Works with both plug in or cordless drill...

This component is what the remote plugs into. Only two different style current limiters were used and the plugs easily differentiate them. Power be...

Used to raise and lower the roof on Coleman's and Fleetwood's equipped with power lift systems. This remote plugs into the current limiter which is...

Used to raise and lower the roof on certain Coleman's and Fleetwood's equipped with power lift systems. This remote has the raise and lower switch ...

Round drive shaft design. The output shaft on this motor has a pin through it. Only two lift motors were used and they are easily identified by the...

Square drive shaft design. Only two lift motors were used and they are easily identified by the shape of the drive coupling. This motor incorporate...

The coupler bushing connects the whiffle tree or whiffle tree extension to the crank assembly in certain lower direct drive lift systems. Always fo...

Square drive coupler to attach the lift motor to the whiffle tree on newer units. This coupler works directly with our square drive lift motor foun...

This is the assembly that is pinned to the back of the power lift motor. In the instance of a failure in the power lift system, you can manually ov...

Adapter that couples the power lift motor to the whiffle tree lift system. Measures 4 inches in length.  Part number 4773-9081

Adapter that couples the power lift motor to the whiffle tree lift system. Measures 6 inches in length. Part number 4768-0851

Mounted to the rear of the trailer, this bracket mounts the power lift motor. Applicable to both round drive and square drive lift motors. Part num...

For use on 1994 Yosemite models. Spacer bracket for the hydraulic cylinder ram. Measures 5-1/2 inches long, 3 inches wide at the base, and 1-3/4 in...

Comes with pump, handle, and hardware. Series 3200 Part number 4755-2151

Hydraulic cylinder for units equipped with a hydraulic lift system. Series 2995, 2910, and 2934. Cylinder measures 26 inches in length. Part number...

Power lift adapter used in Cobalt and Graphite models. Measures 2 inches by 2 inches. 3/4 inch inside diameter hole. Part number 4768-086

For front beds. Series 3857 Part number 4768-5001

For rear beds. Series 3857 Part number 4767-6451

This current limiter was used on units that have the power bed features. Part number 4758-9241

Kit comes with cap, O-ring, and mounting hardware. Cap measures 6-1/2 inches tall by 3-3/4 inches wide. Part number 4716-3031