Search results for “keys”

The coupler connects the whiffle tree or extension rod to the crank assembly. Found on 6311 direct drive systems, and units that use extension rods...

This drive coupler is found in late model units. It acts as a bearing spacer and coupler bushing. Measures 3 Inches tall. Part number 4759-0381

The track guides are attached to the top of the screen door by a cable. The guide accepts into the roof tracks, and suspends the screen door. These...

Installed on the top of the front and rear body panel rails. Acts as a rest for the bed extensions. These caps are found on the left and right, dir...

Control water flow with a quarter-turn pressure seated valve. Y-style converts a single-line hose to two directions. Each side is valve controlled ...

Unique to the Contour Battery Master Switch is the patented contour lock system which allows the switches to be used as stand alone units or locked...

Curbside hutch cabinet door. Removed from a 1995 Destiny Royale.  Series 2989. Measures 13-1/8 inches wide by 15-7/8 inches tall. Part number 4752-...

The whiffle tree is the threaded rod mounted in the bottom of the pop up. A draw bar runs up and down the rod, and pulls or releases the cables. Th...

Cabinet door. Removed from a 1996 Shenandoah series 3090. Located curbside at the lower front cabinet. Measures 16 inches wide by 9-1/8 inches tall...

Commonly referred to as the crank assemblies clutch pad. This plate rides between the ratchet wheel sprocket and chain drive sprocket in chain driv...

Designed for pop ups with one to three 12 volt appliances. Connects the 12 volt battery to the factory harness on Coleman and Fleetwood pop up camp...

Hardware kit for the installation of slide style bed support legs. This kit installs the bed support pole slide channels to the bottom of the bed f...

Sold individually and in ten packs. Two types of rivets are most commonly used in pop up campers. Pop Rivets and Expansion Rivets. Pop Rivets are d...

Complete set of wheel bearings. One kit services one wheel. Kit comes complete with inner and outer bearings and races, seal and cotter pin. The in...

Comes complete with track style guides, new top seal, new spring and sheath, and a new screen door latch. This door has door seal tracks for the ca...

Directly matched to the following unit. 2008 Destiny Yuma Series 4256 Measures 9-1/4 inches wide by 19-1/4 inches tall. Part number 4759B3411-USED

Road side rear body panel. Directly matched to 2000 Grand Tour Elite, Bayside. Series 3478 Measures 47-3/4 inches wide by 24-1/2 inches tall. Part ...

Commonly found on fan light combos and exterior stoves. On the fan lights, this was the original gripper clip that secures it to the poles. For ext...

Used to lock the screen door to the roof when the camper is set up. Lock tabs protrude from the sides of the latch, and lock into brackets installe...

This is the hose that attaches from the propane tank to the low pressure regulator. Pop ups that have 1 LP tank use one hose, campers that have two...

Brass. Measures 3/8 of an inch across. Pack of two. Part number 0322A3301

Road side rear body panel. Directly matched to the following Grand Tour Elite models. 2003 Bayside series 3778 2003 Monterey series 3757 Measures...

Flip up prop lid with hinge. Directly matched to the following units. 1991 Santa Fe Series 3189 2003 Utah Series 3781 Measures 6 inches tall by 3...

Found on small to mid sized Coleman and Fleetwood pop ups with galley lift system sinks and non lift sinks. This hose connects to the drain cup, th...