Coming Back Soon
Filters
4 Stage Lift Arm CSF-RSR Used
The lift arm provides lift to the pop up. They are found in each corner of the camper. CSF / Curb Side Front RSR / Road Side Rear Videos availab...
View full detailsLight Brown T Molding
Used to trim table and countertop sides. Sold in 12 foot length. Long enough to trim the largest table with one run. Choosing the correct size. Yo...
View full detailsPressure Washer
Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...
View full detailsLP Hose
Attaches to the high pressure regulator to the copper line that runs to the exterior stove. 1/4 male MNPT fitting to 3/8 male flare. Measures 30 in...
View full detailsClick Lock Bed Bow 78 X 33
The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the canvas ends. This Click Loc...
View full detailsRoof Corner Cap Kit
Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...
View full details4 Stage Lift Arm CSR-RSF Used
The lift arm provides lift to the pop up. They are found in each corner of the camper. CSR / Curb Side Rear RSF / Road Side Front Videos availab...
View full detailsDrain Hose Strap
Comes with strap and hardware. Strap measures 8-3/4 inches in length. Part number 4716-9691
Common LP Hose - Tank To Regulator -
This LP hose runs from the propane tank to the low pressure regulator. Acme nut to 1/4 inch inverted MPT. Hose measures 15 inches in length. The in...
View full detailsClick Lock Glide Out Bow 71 X 44 Used
The glide out bow provides end canvas support at the dinette. This is the large U shaped pole that folds up from the dinette and holds the canvas e...
View full detailsShower Cabinet Strap
White nylon strap with hook and loop Velcro to secure the shower cabinet top when lifted up. Comes with installation hardware. Measures 30 inches i...
View full detailsLP Hose
Series 4100. 1/2 inch flared male fitting to 3/8 male. Measures 36 inches in length. Part number 4737-8871
Pivot Style Bed Pole Bracket
Bracket for the pivot style bed support poles. This bracket installs under the bed frame, and pins the bed support pole that pivots down. Measures ...
View full detailsABS Roof Brace Kit
Designed for Coleman and Fleetwood campers with ABS tops. This brace kit has a curved design to fit the plastic roofs that have experienced sagging...
View full detailsSink Drain Elbow
Found on many Coleman and Fleetwood pop ups with galley lift system sinks. Installs to the bottom of the sink and connects to the drain hose. Measu...
View full detailsCurtain Clips Pack of 10 Type E
This is one of the most common curtain clips found in Coleman and Fleetwood pop ups. It slides or snaps over the 5/8" curtain track found in many p...
View full detailsABS Roof Seal 41'
4.7 / 5.0
355 Reviews
This is the original Coleman / Fleetwood top seal. It comes by a 41 foot roll to fit any and all Coleman or Fleetwood pop up that has an ABS roof....
View full details