Search results for “tent support bracket”

This bracket is found on ABS roofs that have had a curved roof brace installed. Installed on top of the roof, this bracket holds the carriage bolts...

Right angle bracket. Measures 6 inches by 1-1/2 inches by 3/4 inches. Part number 4741-221

Corner gusset for the curb side front and road side rear location on certain Coleman and Fleetwood pop up campers without a front storage box. This...

Metal bracket used to join bed frame sections together. Holes accept 3/16th sized rivets. Six in total. Measures 7-1/4 inches by 7/8th of an inch. ...

Pole bracket for the sun shade awning systems. This system is designed for roof’s that have two awning rails, one on each side. Over the glide out ...

Found on units produced after 1997. This bracket rivets to the sides of the bed frame, and mounts the bed roller through the center hole. Here is a...

The screen door storage bracket is used to secure the screen door in stored position for closing. This style has pins that accept to the bottom fra...

Found on grey storage boxes on Fleetwood and Somerset campers. Located under the paddle latch, this bracket acts as the lid stop. Measures 3 inches...

Found on front LP cover kits from the 1990's through the mid 2000's. Measures 2 inches by 2 inches. Part number 4747A9471

The screen door storage bracket is used to secure the screen door in stored position for closing the roof. Two latch cams installed. Measures 15-1/...

This is the pole that stabilizes the bed. Two are found under each bed frame in these series. When the bed is pulled out, the pole swings down to t...

Popular in 1980 upper crank assemblies and some early 1990 units. This assembly requires a butterfly key to engage and dis-engage the system. Vide...

Looking for quick relief from the hot afternoon sun? The A&E Systems Trim Line patio awning installs easily on your camper's awning rail, provi...

Roof brace cover. Cover measures 79-1/4 inches long by 5 inches wide. Removed from a 1986 Plantation series Savannah.    Video available Part num...

Mounting bracket for the thermostat. Located behind the plastic base that the thermostat is installed into. This bracket mount it to the inside of ...

This latch is found on the sidewalls holding the roof closed, and storage box bins on pop up campers. Pulling down on the latch clamps the roof and...

Used to secure the awning from the camper to the awning lead rail. Tent support tip accepts into the end of the awning lead rail. The crutch cap re...

This cover bolts to the bottom of the whiffle tree system and adds stability to the lift system. Measures 32-1/4 inches long by 11-1/4 inches wide....

Left hand and right hand table top braces. These braces install at the dinette system to covert it into a bed. Light beige in color. Two braces are...

Found at the rear corner of the glide out, or farthest from the tongue.  Series 3300 Measures 27-1/2 inches long, by 1-1/2 X 1-3/4 inches. Part num...

Puts an end to leaky seams on your canvas. Works on a variety of nylon and synthetic fabrics. 2.0 fl. oz. / 59 ml. Part number 3838040

Base plate mounting kit to add a second LP tank. Installs on top of the pop up A frame. Measures 37-1/4 inches across the top, 28-1/2 inches across...

Commonly found on Pioneer series similar units. This carrier bearing centers the extension rod attached to the whiffle tree. Mounting holes are spa...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. Series 3600. Video available Measures 2 in...