Search results for “tent support bracket”

Shower back angle bracket. Part number 4800B4041

Found on 3 stage highwall lift arms, this is the bottom section. Highwall units typically have body panels that measure 28 inches in height. The to...

This handy strap will keep the swing style door open and secure. Mounted to the top deck with a rivet, this check snaps to a screw stud on the door...

Referred to as the outside stove flap in the parts books, this is the under brace on many stove systems. This swing down brace holds the exterior s...

Propane tank bracket. Measures 2 inches at the base and 1-1/2 inches tall. Part number 4772A9431

Right angle filler bracket with rivets. Painted brown. Series 2300 Measures 3-1/2 inches in length with a 1 inch width on each side. Part number 47...

These clinching ring clamps were primarily used on early shock cord kits. Good for creating clamps on ropes and bungees. Pack of 50 Part number 472...

Rear support bracket for the spare tire.  Popular on 2000's Grand Tour series units. Measures 23-3/4 inches tall by 6-1/8 inches wide. Part number ...

Used on many pop up campers manufactured after 2010. This is the inside and outside latch for the screen door, or entry door. Upgrade for Coleman a...

Rectangular hard plastic slide rails for mid 1990's Destiny series Coleman and Fleetwood pop ups. These slides work with the bed extensions that do...

The coupler connects the whiffle tree or extension rod to the crank assembly. Found on 6311 direct drive systems, and units that use extension rods...

Pin bracket for the shower wand. Found in interior and exterior shower applications. Base measures 2-1/8 inches by 1-5/8 inches. Part number C411

This plate is found in the pulley routing block just past the whiffle tree.  Measures 4-1/4 inches long by 1-3/8 inches tall. Part number 4720F154

This mounting bracket kit is for the LP cover on the 1996 Grand tour series pop ups. Comes with a black angle bracket that measures 5-3/4 inches wi...

Small right angled bracket designed to hold the stove wind guards. Found mounted on the indoor and outdoor stove boxes and cooktops. Measures 1-1/8...

Lower support side bracket for swing style doors. Series 3000. Measures 2-5/8 inches wide by 1 inch by 1 inch. Part number 4749B1278-USED

The cap is the metal bracket that mounts over the plastic front or rear body panel. Metal end rail with double sided tape installed on one side.  P...

Used to hold the lift pulleys in the stage brackets on lift arms. This longer pin is most commonly found at the lower stages. The next upper stage ...

Swivel shower connector for hand held shower wands. This kit comes complete to replace both the shower wand hook and the wall pin. Available in whi...

On the top corners of the deck rails you can find these corner brackets. They stack on top of each other, and cover the four corners of the top rai...

Bracket kit for the installation of plastic LP gas bottle covers. Part number 4716-0991

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSF / Curb Side Front RSR / Road Side Rear Videos availab...

Black hook and loop end Velcro pads. These are commonly found at the corners of the the camper inside the roof, around the doors and exterior top r...

Easy DIY flexible shower track kit for your camper. This kit features an easy to bend track that can be mounted directly to the ceiling. Great for ...